Owner manual

3
High Mount
Twin Coulter
Attachment
Low Mount
Twin Coulter
Attachment
*Twin Coulter Assembly always mounts to front of shank.
Operating Instructions
The twin coulter assembly should be run at eld speeds of 6 to 8 mph.
In rocky conditions lower eld speeds to avoid damaging blades.
When using the twin coulter on the rear of the disk ensure the blades of
twin coulter do not run lower than the blades of the disk
Maintenance
Break in Period
After the rst hour of use, stop eld operation check all carriage bolts
holding the blades for tightness.
Repeat above procedure after rst full day of operation.
Check all bolts and fasteners for tightness every 40 hours of operation.
Failure to comply with the above maintenance guidelines may result in
voiding the warranty.
Summers Mfg. cannot be responsible for damage due to running
8J2000 with loose fasteners.