Instruction Manual

GANGS & SCRAPERS8/15/2012 9CC3212.iam/
8X0260
3/4" N
8X0306
3/4" LW
8K4210
8K5520
3/4 X 6-1/8 X 7-1/2"
8K4200
8X0306
3/4" LW
8X0260
3/4" N
8K5505
3/4 X 2-1/8 X 4-1/4"
8K4420
8J0190
8K5505
3/4 X 2-1/8 X 4-1/4"
8X0318
3/4" FW
(BTTM HOLE
ON 8J0190 ONLY)
8X0306
3/4" LW
8X0260
3/4" N
2-54
SECTION 2 – INSTALLATION OF SHANKS AND COULTER GANGS
1. Gang Mounting – Start from the center and work towards the outside when hanging the gangs.
Bearing location is important, use correct gang assembly for each location. Carefully lift gang to
frame close to correct location. Attach C-shanks to frame using (2) 3/4” U-bolts, mounting plate
with peg, at mounting plate, lockwashers and nuts. After both C- shanks on each gang are
mounted, slide the gang to its proper location and tighten hardware.
2. Scraper Mounting – Attach scraper mounting tubes to scraper support brackets (8J0200) using
3/4” U-bolts (8K5505), spacer at (8K4420), lockwashers and nuts. Attach scraper ats (8J0190)
to the mounting tubes using 3/4” U-bolts (8K5505), atwashers (lower hole only), lockwashers
and nuts. Center between coulter blades.
Locations are shown in the following pages