Manual
SECTION 3 – OPERATION
3-2
INITIAL HOOKUP:
1. Make tractor to hitch connection with locking draw pin and safety chain.
2. Retract jack and rotate into storage position.
3. Insure that tips and couplers are CLEAN. Plug Center Tilt Cylinder hoses into desired tractor
outlet. Adjust hydraulic ow rate to 35% of maximum.
4. Plug Wing Lift Cylinder hoses into desired tractor outlet. Adjust hydraulic ow rate to 35% of
maximum.
5. Connect safety Light Kit wiring harness to 7 pin receptacle.
6. If Land Roller is in Transport Position, follow “Steps Required to Unfold from Transport to Field
Position”, page 3-3.
7. INITIAL CHECK – with machine in Field Position
A. After receiving or assembling your Land Roller, it is a good practice to double check the entire
machine so all fasteners are securely tightened.
B. Make sure all grease ttings are in place and greased properly.
C. Inate tires to recommended ination pressure (see page 4-2), check that wheel nuts are
tightened to 240 ft-lb and check that wheel bearings are correctly adjusted.
NOTE: The rst time the Land Roller is folded into Transport Position and after any machine ad-
justment, it is very important to follow “STEPS REQUIRED TO FOLD FROM FIELD TO
TRANSPORT POSITION”, page 3-5. In addition to these steps, it is very important to retract
hydraulic cylinders slowly to insure Cylinder Attach Eye Bolts are correctly adjusted and that
hydraulic hoses and wires are not stretched or pinched.