Use and Care Guide

PELLET START-UP PROCEDURE

If the unit does not start or maintain a fire, you will receive an E-2 in the Heat Range and Blower

Speed window of the Control Board. If this occurs, wait until unit has cooled completely down and

repeat.

To remove the Stirrer for cleaning

While the unit is COLD and the unit is off, press and hold the Air On Temp button until the Stirrer

is at the “12:00” position. Pull the hitch pin (marked in Illustration 3). Lifting the Burnpot and Stirrer at

the same time, remove the Stirrer from the Burnpot. Clean and clear all holes in the Burnpot and

replace Stirrer and Burnpot back into the unit.

NOTE: When replacing the Burnpot, notice there is a welded piece that is always set toward the

back of the Firebox.

Illustration 3

Locking

Collar

Illustration 4

Hitch Pin