Use and Care Guide

OPERATING INSTRUCTIONS

CAUTION: DO NOT OPERATE WITH THE DOOR OPEN.

Do not burn trash (paper bags, etc.) in this unit.

This stove has an induced draft system and is designed to operate continuously, as frequent

shutdown is not required. The setting of the “Heat Range” touch pad will control the heat output

and the amount of fuel the unit will burn (see “Control Board” section).

NOTE: This stove is using solid fuel and will not restart automatically unless a thermostat is

installed. See page 26 – Thermostat instructions.

* NOTE: Blower Speed will automatically be adjusted to the desired Heat Range that you select.

START- UP PROCEDURES

SETTING THE STIRRER

Warning: Do not open the door on this unit if the Stirrer is still moving!

Bodily Injury can occur!

The Stirrer may be turned Off by pushing the “Air On” button on the bottom of the Control Panel,

and then pressing both Down

arrows on the “Blower Speed” and “Heat Range” until you see a “0” in

the Blower Speed window.

The Stirrer may be turned back On by pressing the “Air On” button on the bottom of the Control

Panel, and then pressing both Up

arrows on the “Blower Speed” and “Heat Range” until you see a

“1” in the Blower Speed window.

CAUTION: Never use gasoline, lantern fuel, kerosene, charcoal lighter fluid, diesel fuel or

any other flammable liquid to start the fire. Keep all combustible materials at a

safe distance from stove.

The Heat Range and Blower Speed will automatically be set to setting “5” (default setting during

start up) to ensure that proof of fire is detected. During the 20 minute start-up period the user can set

the controls to a desired heat setting and after the 20 minute start-up the unit will operate at that user

setting. When burning corn, start-up period is 30 minutes.

Stirrer

–

Ill

ustration

This lug must be in the upright

position when restarting the stove