Warranty

16
Should you encounter any problems, contact Customer Service at [phone] from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
5. Please see Pool Support - Filtration System Troubleshooting for the RP350/RP400 Filtration System at support.polygroupstore.com.
PLEASE NOTE: Even if the rotor assembly is in perfect condition; if it is not seated properly between the volute housing and the pump it will not function correctly.
6. To reassemble the pump (Motor Assembly): Carefully insert the Rotor Assembly 20 into the Pump Motor Body 19 . The force of the magnet will pull the rotor
assembly into the pump. Ensure that the Rotor Assembly is completely assembled and aligned correctly inside the pump body.
7. Once the rotor has been inserted, fasten the volute housing tabs back under the brackets of pump body by turning the volute housing discharge nozzle clockwise.
8. Tighten the Volute Housing 21 With the Volute Cover Screw Set 22 to complete the reassembly of the pump (Motor Assembly).
9. Slowly insert the Motor Assembly 17 back into the Canister 16 , and fasten the Motor Assembly 17 With Motor Assembly Washer and Screw Set 25 .
19
20
21
22
Volute Hosing
Discharge Nozzle
Slide the tabs of Volute Housing
underneath the brackets of
Pump Body to lock
Brackets on pump body
Rotor Assembly
Shaft End Cap
Washer
Impeller
Magnet Axle
Rotor Shaft
(This shaft should go through
all the parts and into both
Shaft End Caps)
Washer
Shaft End Cap
pump body
Volute Housing Screws