Warranty

OWNER’S MANUAL
13
Should you encounter any problems, contact Customer Service at [phone] from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
POOL MAINTENANCE
NOTE :
1. Hot weather/heavy use may require pH and chlorine levels to be maintained on the upper side of the scale and superchlorination of the pool every week.
2. Using a pool cover and/or solar cover (available at polygroupstore.com) will assist in maintaining your pH and chlorine levels by reducing the amount of evaporation
from your pool.
CAUTION - Concentrated chlorine levels and low pH levels will damage pool. You must follow the instructions for the pool chemicals you use, as to quantity and
recommended usage. NEVER drop lumps or pellets of chemicals in pool; this may present a hazard to swimmers and/or damage your liner.
1. The following items are required to get your pool ready for use. They are available at polygroupstore.com or
your local pool supplies stores:
• Test Kit - Used to check chlorine and pH levels.
• 1” Chlorine Tablets - Used to disinfect pool water and help control the growth of algae.
• pH Control Chemicals - Used to adjust pH levels Up (Soda Ash) or Down (Acid).
• Algaecides - Used to eliminate algae.
• Superchlorinator - Used to destroy combined chlorine, ammonia, nitrogen, and organic compounds.
• Leaf / Skimmer Net with handle - Used to remove leaves, trash, insects, etc. from your pool.
This item can be purchased at polygroupstore.com.
• Chlorine Dispenser (Supplied with Polygroup
®
’s patented Filter Cartridge U.S. Pat. 7,005,062) - Used to
dispense 1” chlorine tablets ONLY.
2. Use test kit daily to check pH and chlorine levels. Adjust accordingly using the required chemicals.
NOTE: Excessive levels of chlorine or low pH levels will damage pool liner.
3. The pool can be cleaned using a garden hose powered vacuum from Polygroup
®
or a pool supply store.
4. Using a foot bath near the pool to wash off your feet prior to entering the pool will assist in keeping the pool clean.
5. Well water often presents special problems with water chemistry. If you must use well water, take a sample to your local pool chemical supplier for analysis before
adding ANY chemicals.
6. Refer to the retail package box or visit the support pages at support.polygroupstore.com for the capacity of your pool. You will need this
information to determine the amount of chemicals you will need to correct the pool water. NOTE: It is recommended to use a 5 gallon bucket of water to mix and
dissolve your chemicals and then applying directly to the pool water. Follow manufacturer’s label directions on all chemicals. *Most pool supply stores will test your
pool water for free and advise you of what chemicals you need, and the correct amount to use for your pool. You will need to tell them the pool capacity in gallons.
7. IMPORTANT - We cannot emphasize enough the importance of proper and adequate daily chemical treatment. Chlorine and pH levels must be properly
maintained at all times. PUMP AND FILTER ALONE WILL NOT PREVENT ALGAE FROM GROWING IN POOL WATER; THIS CAN ONLY BE DONY BE
MAINTAINING PROPER CHLORINE AND pH LEVELS AT ALL TIMES.
• Maintain pH level between 7.3 and 7.8.
• Maintain chlorine level between 1.0 and 1.6 ppm (parts per million).
• Superchlorinate your pool at least every other week.
POOL WATER CARE
6. Suntan oils, body oils, and algae can form a coating on the filter pleats which may not be thoroughly removed by hosing. Such films of oils and/or algae will rapidly
clog up the filters’ pores, greatly reducing filtration. Therefore, it is imperative to remove such materials from the filter element as soon as possible. To remove oils,
we recommend soaking the cartridge in a solution of 1 lb. of tri-sodium phosphate (TSP or any other strong detergent) to 5 gallons of water for up to 12 hours.
Tri-sodium phosphate is available in many supermarkets, hardware stores, or janitorial supply stores. After the oils have been removed, rinse the filter cartridge to
remove any dirt. If algae is a problem, add 1/2 pint of pool chlorine or 1 pint of liquid household bleach to the cleaning solution, 1 hour before removing the filter
cartridge from the solution. Thoroughly rinse the filter cartridge before replacing it in the filter case. Check the pool chemistry to determine the cause of algae growth.
7. Excessive calcium and/or mineral deposits may build up on a filter cartridge and should be handled differently. Contact your local pool supply store to ask about
additional filter cartridge cleaners or treatment for calcium or mineral deposits. Check pool chemistry for high pH or alkalinity; this may cause a calcium or mineral
build-up.
8. A spare “stand-by” Filter Cartridge 18 is an excellent investment. It provides a convenient way to continue filtration of your pool while cleaning or replacing a dirty
Filter Cartridge 18 . Also, a well-maintained, clean cartridge assures you that your filter will always be ready to operate at peak efficiency.
9. Filter cartridges may be purchased at the store you purchased your pool from, or ordered from Polygroup
®
at polygroupstore.com. Always replace with genuine
Polygroup
®
SUMMER WAVES
®
filter cartridges.
Chlorine Tablets
1. Check and adjust pH and chlorine levels daily using required chemicals. See Section “POOL WATER CARE.” or contact your local pool store.
2. Check filter pump output daily. If flow is reduced, see Symptom 2 in Section “TROUBLESHOOTING GUIDE.”
3. Check filter pump, hoses and fitting for leaks. If a leak is found, see Symptom 4 in Section “TROUBLESHOOTING GUIDE.”
4. Run the pump for the recommended number of hours daily. If you are unsure of the time frame please refer to support.polygroupstore.com for the recommended
"Pump Operation Hours" bases on pool types and sizes.