Instructions / Assembly

6. Carefully slide the Horizontal Beams 2
into the sleeves of the pool.
7. Connect the T-Fitting 4 to Horizontal Beam 2
10. Look through the hole in the fitting as you insert and rotate the
pipe until the buttons align with the holes and pop out, locking
the leg in place.
11. Go around and check all fittings, legs, and beams are
properly installed and secured in place. Make sure the
drain fitting is plugged securely and the cap is in place.
12. Start filling the pool with water until 1-inch of water is on the bottom; then, stop filling and smooth wrinkles out of
the pool bottom. Push outward from inside the pool removing all wrinkles so that it fills evenly and flat.
IF MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS FILLING
IN THE CENTER, THE POOL IS NOT LEVEL ENOUGH, AND MUST BE CORRECTED.
2
2
4
4
8. Insert the Pin 6 down through the top of the T-Fittings
until the Pin snaps into place on the lower side of the fitting.
6
9. Carefully slide the Vertical Leg 3 down through the belt that
runs around the middle of the pool.
• For smaller pools without a belt, slide the vertical leg through the
sleeves on the pool wall.
3
3
Should you encounter any problems, contact Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.
10