Instructions / Assembly

12
• IF YOUR POOL INCLUDES A COMPLETE FILTRATION SYSTEM WE RECOMMEND THAT YOU COMPLETELY INSTALL THE ENTIRE FILTRATION SYSTEM
FIRST BEFORE PUTTING ANY WATER IN YOUR POOL TO AVOID WATER LOSS.
• FOLLOW THE "SETUP INSTRUCTIONS" IN THE FILTER PUMP SYSTEM OWNER’S MANUAL TO INSTALL THE SYSTEM, THE POOL WALL FITTING(S)
AND ALL HOSES AND CLAMPS BEFORE PUTTING ANY WATER IN YOUR POOL.
15. Make sure the liner drain fitting is plugged securely and the cap is in place. Then start filling the pool with water.
AFTER ABOUT 1 INCH OF WATER IS ON THE BOTTOM, STOP FILLING AND COMPLETELY SMOOTH OUT ALL THE WRINKLES ON THE BOTTOM OF THE POOL,
WORKING OUTWARDS FROM THE CENTER. MAKE SURE THE FLOOR OF THE POOL IS COMPLETELY FLAT SO THAT THE POOL FILLS EVENLY.
IMPORTANT: IF MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS FILLING IN THE CENTER, THE POOL IS NOT
LEVEL ENOUGH, AND MUST BE CORRECTED. SEE "SITE PREPARATION" (p. 9).
ADDITIONAL NOTE: THE WEIGHT OF THE WATER WILL PREVENT ADJUSTMENT AFTER THIS POINT.
NOT FOLLOWING THE STEPS ABOVE WILL MAKE THE POOL FILL UNEVENLY AND THE POOL MAY LEAN TO ONE SIDE AND COLLAPSE. THE WATER IN
YOUR POOL SHOULD FILL EVENLY. IF YOUR POOL IS LEANING AT ALL; THE GROUND MAY NOT BE LEVEL AND YOU WILL NEED TO START OVER.
• FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE WILL CAUSE POOL TO COLLAPSE AND WILL VOID THE WARRANTY!
16. When the water is approximately half filled, the top frame will tend to bend down in the middle as shown below.
THIS IS ABSOLUTELY NORMAL.
Continue to fill with water up to the fill line printed on the inside of the liner wall, the frame will restore to its normal shape.
IMPORTANT: FOR POOLS THAT INCLUDE A COMPLETE FILTRATION SYSTEM.