Instructions / Assembly

10
10. Rotate the short and long tubes to align the holes in the tubes
with the openings on the sleeves.
Swedged End
Swedged End
Swedged End
x4
2
2
2
2
2
2
2
2
2
2
4 4
8. Connect the Short Tubes
4
.
See NOTE below.
NOTE: Refer to the part list on page 7 & 8 for the exact
quantity of Short Tubes
4
. Connect half the
total quantity to form the horizontal beams on
the short sides of the pool.
9. Carefully slide the connected Short Tubes
4
into the sleeves
on the short sides of the pool.
4
4
• Align the holes of
4
and
5
with the sleeve openings.
• Make sure all the swedged ends of
4
and
5
are pointing to the clockwise direction.
4
5
3
3
3
3
11. Connect the Corner Pieces
3
to the tubes at each of the 4
Corners. You should have a closed rectangular pool frame;
which is the frame around the top of the pool.
NOTE: The Corner Pieces
3
DO NOT have holes to catch the
spring pins. THIS IS NORMAL. Only the Long and Short Tubes
4
&
5
have holes to catch the spring pins.
2
12. Insert the U-Shaped Pipes
2
into the straps at the bottom of
the pool.
13. Continue to insert all of the U-Shaped Pipes
2
as shown below.