Operations and Maintenance Manual

70-STR1800-00 Rev K STR-1800 O&M Manual
- 5 -
SECTION 2 RECEIVING, INSPECTION AND
INSTALLATION
2.1 Unloading and Unpacking
NOTE
If shipping carton is damaged upon receipt, request carrier’s agent
be present during unpacking and inspection of the system.
Upon receipt of the equipment, inspect the shipping container for damage. If the container or the
cushioning material is found damaged, they should be kept until the contents of the shipment have been
verified for completeness and the equipment has been inspected for mechanical and electrical defects. If the
contents are incomplete or if there is a mechanical or electrical defect, please notify:
SUMMATION RESEARCH, INCORPORATED
305 East Dr, Ste D
Melbourne, Florida 32904 USA
2.2 Receiving Documentation
Each STR-1800 radio is shipped with a packing slip. The packing slip should be carefully checked against
the contents of the shipping container.
2.3 Installation and Connection Requirements
The STR-1800 has four (4) connectors. These are:
1) Primary Power
2) Antenna
3) Audio/control
4) Programming/diagnostic
After carefully reviewing the connector and signal descriptions below, the user should establish all
connections, making sure that the primary power input is turned off at the source. Once all interconnections
are in place, primary power may be applied.
.