Instructions / Assembly

HINGEDTREE
ASSEMBLYINSTRUCTION

HELPFULHINTS:
Pleasereadtheinstructioncompletelybeforeyou
assembleyourtree.Themodelnumberofyour
treewasprintedonthesideofthecarton.Always
use this number to identify your tree if any
questionarises.
Savethecartonforstoringyourtree.
Useminiaturetreelights.
Thestandshownheremaydifferfromthestand
whichyoursupplier provided.

ASSEMBLY
1. Assemble – Insert tree pole into the stand. If
the tree was divided into two sections, please
assemblethetwosections,placepoleandsecure
tightintostand.

2. Shape the branches – Start from branches
nearesttopole.Fanoutonetiptotheleft,oneto
therightandoneatthecenterofthemainstem.
Alternate branches to avoid they line up after
others.Attheendofthestem,thetipsofcenter
branch should be extended straight out. Curve
each branch slightly to make the tree have a
naturallook.

3.Shapethetopsection–Pulldownbranchesof
the lowest layer in an even circular pattern and
repeat for each layer till the top branch. Curve
eachbranchandtopbranchstraightuptoafixed
position.

4.Inserttreetopsectionintotheholeandmakesurethepoleisfirmlyinsertedintothenextsection.
Thetreetopshouldconformtotherestoftree.


Storagetips:
Pullouttheplugandremoveornaments.
DONOTstorethetreeinadampareawherethetemperatureisover40°C.
BRANCHESINUPRIGHT
WILLUNFOLDDOWN
AUTOMATICALLY.
POSITIONBRANCHESCORRECTLYTO
THEHINGEJOINT.