Quick set-up User Manual

ManualsBrandsSulky ManualsControl panelVISION 2 DPB

DPB POLYVRAC AND OR XLT : QUICK-START GUIDE

Réf: 400 369 - 02 - GB / DIS

06/2009

Choice of menus

Numeric keypad

On/off switch

Factory and diagnostic

parameters

Backspace

Data confirmation

Á There is a choice of 3 menus setting menu (SET)

spreading menu (

MAIN)

information menu (

INFO)

Á Fit the power cables

Supply for the Vision control box

Cobo plug inside the tractor cab

Supply for the actuators (the big cable )

Direct from the 12 Volt battery

Á When setting up, follow these instructions

•

• Calibrate the forward speed.

•

• Program the working width.

•

• Choose a product (A, B, C…) and confirm the machine parameters

(floor belt speed, shutter rate reducer)

•

• Set the quantity/ha.

•

• Perform a rate calibration test (T factor)

GENERAL PRESENTATION

Summary of content (4 pages)

PAGE 1
DPB POLYVRAC AND OR XLT : QUICK-START GUIDE GENERAL PRESENTATION Choice of menus Numeric keypad Data confirmation On/off switch Backspace Factory and diagnostic parameters Á There is a choice of 3 menus setting menu spreading menu information menu (SET) (MAIN) (INFO) Á Fit the power cables Supply for the Vision control box Á Cobo plug inside the tractor cab Supply for the actuators (the big cable ) Á Direct from the 12 Volt battery Á When setting up, follow these instructions • • 1 • Calibrate t
PAGE 2
DPB : QUICK-START GUIDE BEFORE FILLING THE MACHINE • 1 • CALIBRATE THE FORWARD SPEED OVER 100 M THE BELT MUST BE ENGAGED TIME / DATE CONTRAST / BRIGHTNESS UNITS LANGUAGE HELPLINE C HOICE OF INSTRUMENTS INDICE B15 - Press on . (choose tractor n°1) - Press on . - Position the cursor on «calibration over 100 m» with . SET menu 1 2 - Press on . (data confirmation) - Once in front of the first mark press on . 3 - Then, follow the on-screen instructions.
PAGE 3
DPB : QUICK-START GUIDE Shows if the electric shutters are opened or closed MAIN menu Shows the type of fertiliser 4 Shows the electric actuator position 5 Enables adjustment of rate per hectare • Press to operate the TRIBORD and select the right / left or both discs for rate modulation 4 • S ET THE QUANTITY PER HA - Use the numeric keypad - Confirm with . • 5 • PERFORM A RATE CALIBRATION TEST W H EN - The T-factor has been updated and you are now ready to work. U S I NG TH E BUC KETS .
PAGE 4
DPB : QUICK-START GUIDE Tons spread Information menu Area covered Choice of either PARTIAL or TOTAL counter for: . Tons spread .