Quick set-up Owner manual

ManualsBrandsSulky ManualsControl panelVISION 2 DPB

VISION II DPB : QUICK-START GUIDE

Réf: 400 355 - 00 - GB / DIS

03/2008

Menu selection

Numeric keypad

Power On/Off

Factory parameters

and diagnostic

Backspace

Data confirmation

Á There is a choice of 3 menus : Spreading menu (MAIN)

Information menu (

INFO)

Setting menu (

SET)

Á Fit a speed sensor ideally on the front transmission shaft (a semi-circular magnet) or on the

wheels : front wheel

4 magnets

rear wheel

8 magnets

If the tractor has a radar or speed sensor, it is possible to connect directly using a special

plug to the tractor's original socket.

Á When setting up the DPB, follow these steps in order :

•

• Calibrate the forward speed.

•

• Set the working width.

•

• Choose a product (A, B, C…).

•

• Do a rate calibration test (T factor).

•

• Set the quantity / ha.

GENERAL PRESENTATION

Summary of content (4 pages)

PAGE 1
VISION II DPB : QUICK-START GUIDE GENERAL PRESENTATION Menu selection Numeric keypad Data confirmation Power On/Off Backspace Factory parameters and diagnostic Á There is a choice of 3 menus : Spreading menu Information menu Setting menu (MAIN) (INFO) (SET) Á Fit a speed sensor ideally on the front transmission shaft (a semi-circular magnet) or on the wheels : front wheel Á 4 magnets rear wheel Á 8 magnets If the tractor has a radar or speed sensor, it is possible to connect directly using a specia
PAGE 2
VISION II DPB : QUICK-START GUIDE • 1 • CALIBRATING THE FORWARD SPEED ON A DISTANCE OF 100 m - Press on . (choose tractor n°1) - Press on . - Move the cursor to "calibrate over 100 m" with . Setting menu - Press on . (confirm data) - Once in front of the first mark, press . 1 2 - Then follow the on-screen instructions. - At the end, press to exit. 3 • 2 • S ETTING THE WORKING WIDTH - Use the numeric keypad, confirm with . • - At the end, press exit.
PAGE 3
VISION II DPB : QUICK-START GUIDE Shows if the hydraulic shutters are open or closed Shows the type of fertiliser Spreading menu 5 Shows the position of the electric actuators Use these keys to modulate the rate/ha. The 100% key brings you back to the initial rate. 4 Use this to control the TRIBORD 3D. Yield borders Use to select the right, left or both discs for modulation Environment borders • 5 • S ETTING THE QUANTITY PER HA - Use the numeric keypad, confirm with .
PAGE 4
VISION II DPB : QUICK-START GUIDE Tons spread Information menu Area covered Choice of either PARTIAL or TOTAL counter for : . tons spread . area covered Use to reset counters Shows current alamrs Use this to download information onto a computer, GPS or printer.