Manual

59
FR
GB
DE
Entretien / Maintenance / Wartung
Changement des dents
a) Dents boulonnées
Les dents de la herse doivent être changées avant
une usure trop importante qui pourrait
endommager les rotors.
- Changer les dents l’une après l’autre pour ne pas
faire d’erreur de montage
RÉFÉRENCE: dent droite 980146
dent gauche 980145
dent droite traité carbure 980132
dent gauche traité carbure 980131
bride 720341
vis TEB 16 x 52 x45 12,9 720342
vis TEB 16 x 57 x1,5 12,9 720400
rondelle 720400
- Monter les dents de façon à ce q’elles soient en
position traînante par rapport au sens de rotation.
Le montage dans l’autre sens des dents est
possible dans le cas d’utilisation très précise sur
mulch profond (nous consulter).
- Utiliser les vis d’origine et serrer à un couple de
40 mKg.
Il est conseillé de changer les vis et les brides après
deux jeux de dent minimum.
Replacing the tines
a) Bolt-on tines
The tines on the harrow must be replaced before
excess wear causes damage to the rotors.
- Replace the tines one at a time to prevent any
mix-up when fitting.
R
EFERENCE NO. RH tine 980146
LH tine 980145
Carbon-coated RH tine 980132
Carbon-coated LH tine 980131
Clamp 720341
TEB bolt 16 x 52 x45 12,9 720342
TEB bolt 16 x 57 x1,5 12,9 720400
washer 720400
- Fit the tines so that they trail in the direction of
rotation.
The tines may be fitted the other way round for
special use on deep mulching (consult us).
- Use the bolts that are supplied and tighten to the
following torque: 40 mKg.
You are advised to replace the bolts and clamps
after at least two sets of tines have been used.
E
E
E
1
5
Auswechseln der Zinken
a) Verschraubte Zinken
Die Eggenzinken sollten vor allzu großem
Verschleiß ausgewechselt werden, der die Rotoren
beschädigen könnte.
- Zinken einen nach dem anderen auswechseln, um
vor Montagefehlern sicher zu sein.
Artikelnummer Rechter Zinken 980146
Linker Zinken 980145
Rechter Zinken
karbidbeschichtet 980132
Linker Zinken
karbidbeschichtet 980131
Flansch 720341
Schraube TEB
16 x 52 x45 12,9 720342
Schraube TEB
16 x 57 x1,5 12,9 720400
Scheibe 720400
- Zinken so montieren, dass sie sich gegenüber
dem Drehsinn in Schleppstellung befinden.
Die umgekehrt gerichtete Montage ist möglich bei
ganz bestimmten Arbeiten in tiefem Mulch
(wenden Sie sich an uns).
- Originalschrauben verwenden und auf ein
Anziehdrehmoment von 40 mKg festdrehen.
Es wird empfohlen, die Schrauben und Flansche
mindestens nach zweimaligem Auswechseln der
Zinken auszuwechseln.