User manual
4
FRONT PANEL
DI LEVEL
Adjusts the output level of the balanced and unbalanced DI / Line Out outputs (located
on the rear panel). DI Level is used to optimize the amount of signal the Reactive Load
delivers to your device.
NOTE: The maximum DI signal voltage is approximately 17% of the amp’s output
voltage.
IMPORTANT: When using the Reactive Load without a speaker cabinet connected,
there may be a tendency to push your amplier's output level higher than normal. We
recommend using settings you are familiar with to avoid damaging your amplier.
LED
This indicator provides a visual representation of the signal ow from your amplier to
the Reactive Load.
NOTE: The LED’s strength is based on the amplier’s output power. At lower power
levels, it is normal for the LED to appear dim.
FAN
The Reactive Load contains an internal fan which is powered by your amplier’s
speaker output voltage and designed to maintain the temperature of the Reactive
Load's external surfaces.The fan automatically turns on/off based on the amount of
power delivered to the unit’s Input.
NOTE: The fan will begin to operate when the input power is greater than 25 watts.