Installation Sheet

Caution
Caution
Caution
Caution
a. DEAL DRAWING
Screw cover
Screw cover
Vertical
adjustment screw
Vertical
adjustment screw
Main body
Base frame
HES3D-190取説 hes3d12.EPS
b. INSTALLATIONS DOOR
ADJUSTMENTS
Door
Door
Frame
Backward
Forward
Left
Right
Up
Down
Horizontal
adjustment screw
Horizontal
adjustment screw
Backward/forward
adjustment screw
Backward/forward
adjustment screw
Vertical adjustment screw
Vertical adjustment screw
INSTALLATION PROCESS
Make sure the base frame will be set firmly in the proper direction
before installing into the bored hole of the frame.
Do not open/close door with excessive force, or door may fall.
Remove screw cover and vertical adjustment screw from
hinge body. Separate door side leaf and base frame. Repeat
process for remaining hinge.
Install door side leaf into the bored hole of the door with
installation screws (Flat head M4.8 X 25). Then, with screws,
install the base frame into the bored hole of the door frame.
Repeat process for remaining hinge.
Refer to Figure B. Temporarily hang the door by inserting both
upper and lower main hinge bodies into the upper and lower
base frames at the same time. The door will be temporarily
held in place by the easy installation function.
Insert vertical adjustment screws (removed in Step 1) into
vertical adjustment holes. With a hex key (M4), loosely fasten
screws to temporarily hold frame side leaf in place.
ADJUSTMENTS
To prevent door from falling, do not remove backward/forward
adjustment screw.
Make adjustments in each (vertical and backward/forward)
direction.
Vertical adjustment
Using hex key (M4), loosen vertical adjustment screw just one
turn. Temporarily hold door in place during adjustment of door
height by inserting a piece of wood in gap between floor and
bottom of door. Then tighten screws. Fastening torque is 4.9N
.
m (50kgf
.
cm).
Backward/forward adjustment
Loosen backward/forward adjustment screw just one turn using
hex key (M4). Adjust the door. Then tighten screws. Fastening
torque is 4.9N
.
m (50kgf
.
cm).
Horizontal adjustment
To widen the gap between door and door frame (on the hinged
side of door), turn the horizontal adjustment screw in clockwise
direction. (Maximum adjustment is 3 mm). To narrow the gap,
turn the screw in counter clockwise direction.
Gently turn adjustment screws, alternating from one screw to the
other and back again. Do not force turning of screws.
Do not loosen adjustment screw (Maximum adjustment is 3mm) in
clockwise
direction, or door may fall.
Finally, replace screw cover.
Door
Door
Frame
HES3D-190取説 hes3d13.EPS
Do not handle the covers with excessive force, or covers may
broken.
2012.●● PRINTEDINJAPAN ●●●●-●