User's Manual

Suga Electronics Limited
Page 16 of 19
4. All wireless access points in proximity will be displayed here. If the access point
You want to use is not displayed here, please try to move your computer closer to the
Access point or you can click Refresh network list to rescan access points. Click the
Access point you want to use if it’s shown, then click Connect.
5. If the access point is protected by encryption, you have to input its security key or
passphrase here. It must match the encryption setting on the access point. If the access
point you selected does not use encryption, you’ll not be prompted for security key or
passphrase.
6. If you can see Connected message, the connection between your computer and
wireless access point is successfully established.
Chapter 4: Regulatory information
FCC Information to User
FCC caution:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Electronic Emission Notices :
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference ,and
(2) This device must accept any interference receive d, including interference that
may cause undesired operation