User's Manual

Suga Electronics Limited
Page 13 of 19
Encryption field of the access point you selected None, you’ll be connected to
this wireless access point within one minute). Please jump to next step. If the
access point you selected enables encryption, please proceed to next step.
4. If the wireless access point uses encryption, please setting in the dialog box as
Figure 3-3, you have to input WEP passphrase or WPA preshared key. Please
ask the owner of the wireless access point you want to connect, and input the
correct phassphrase / preshared key here, then click OK.
5. open the tab Advanced as Figure 3-4, you can set some advanced setting in here
 Wireless mode – Select wireless operation mode, available options are 2.4G.
 Enable Tx Burst – Check this box to accelerate the data transmit rate, it may
not work with all wireless access point and wireless devices.
 Enable TCP Window Size – Check this box and the configuration utility
will adjust TCP window size automatically, to get better performance. It
should be safe for most of wireless environments, but if you found some
problem on data transfer, uncheck this box.
 Fast Roaming at – Check this box and you can adjust the threshold of when
this wireless network card should switch to another wireless access point
with better signal quality. Only adjust value when you understand what it
means.
 Select Your Country Region Code – Select the country / region code of the
place you’re living. Different country / region have different regulations on
wireless devices, and it is forbidden to use certain channel (radio frequency)
in some countries or regions. The operating frequency channel will be
restricted to the country / region user located before importing.
 Show Authentication Status Dialog – When you computer is being
authenticated by wireless authentication server, a dialog window with the