Installation Instructions

Integrated Dual Installation
(Hinge to Hinge)
subzero.com 800.222.7820
page 1 of 2
7029832 REV-C 02/2016
CONTENTS
1 Heater
1 Grommet, plastic
2 Screw, #8–18 x
5
⁄8"
2 Trim, edge guard
1 Plug, 4-pin
2 Tape, black
2 Bracket, mounting hinge–top
1 Bracket, mounting bottom
2 Screw, #10 x
1
⁄2"
2 Screw,
1
⁄4" –20 x
1
⁄2"
2 Screw, #10–24 x
1
⁄2"
1 Trim, center
2 Screw, #10 x
3
⁄4" self drilling
2 Screw, #8–32 x
1
⁄2"
1 Instructions
HEATER INSTALLATION
1 Insert a plastic grommet in the front square hole along
the top edge of the unit, then tap into position.
2 Remove the paper backing from the tape on the back of
the heater.
3 Place heater panel on the left side of the unit being
installed on the right, insert two screws along the top
edge, then press rmly to secure.
Refer to the illustration below.
4 Install edge guard along the upper edge of the opening
and bottom of the heater panel where wires pass. Edge
guard must be trimmed to t.
5 Place leads from heater into the correct pin position on
connector. Pin position is dependent on the model being
installed. Refer to pin placement illustration and chart
below. Place excess wire into opening or secure to the
side of the unit with tape provided.
MODEL WIRE PLACEMENT
All Refrigerator, Wine (Single Door) 2, 4
All Freezer, Combination and Wine
(Door and Drawers)
1, 2
Heater placement.
EDGE
GUARDS
4
3
2
1
PIN ONE
REFERENCE
Electrical connection. Pin placement.