Product Manual

www.ssilocators.com

SERIES

The reCeIver is capable of locating power utility frequencies. This mode is useful for locating

underground primary and secondary power utilities. In certain circumstances, this mode will also

locate water pipes, sewer lines, cable television, and telephone. The reason is that common electrical

grounds are sometimes found among these various utilities. Select 50Hz or 60Hz frequency on the

Receiver. PINPOINT Peak mode will automatically be selected as the preferred method to locate the

conductor in passive power mode.

This method is useful because of its speed and convenience. Start at a known reference point and keep

in mind that other conductors in the area may produce this same locating signal.

The Transmitter is not required to locate in this mode.

note: The unit of depth measurement determines the selection of either 50Hz or 60Hz passive

mode. The unit is configured for 50Hz when in Metric Measurement mode and 60Hz when in English

Measurement Mode. To change unit of measurement press and hold the frequency button for 10

seconds, when released the unit will toggle measurement units.

The

pl-vf reCeIver is capable of passively locating metallic utilities where radio frequencies have

coupled to the utility. This mode is useful for sweeping a green area for utilities. In certain circumstances,

this mode will locate water pipes, cable television, gas lines and telephone. This locating option does

not always detect buried utilities even when radio frequencies are present. This method is useful

because of its speed and convenience. Start at a known reference point and keep in mind that other

conductors in the area may produce this same locating signal.

The

tranSmItter is not required to locate in this mode.

The pl-vf reCeIver is capable of locating the rectified signal of Cathodically Protected utilities at

120Hz and 100Hz. This method is useful because of its speed and convenience. Start at a known

reference point and keep in mind that other conductors in the area may produce this same locating

signal.

Note: The unit of depth measurement determines the selection of either 100Hz or 120Hz passive mode.

The unit is configured for 100Hz when in Metric Measurement mode (for 50Hz power) and 120Hz (for

60Hz power) when in English Measurement Mode. To change unit of measurement press and hold the

frequency button for 10 seconds, when released the unit will toggle measurement units.

The

tranSmItter is not required to locate in this mode.

passive 50/60 hz loCating

passive radio freQuenCy loCating

passive reCtifier Cp loCating