Product Manual

Maintenance

Keep the unit as clean as possible, especially the Electronics key-

pad panel. Do not use an abrasive cleaner on the keypad overlay

or the LCD lens.

Be sure to wire your cables correctly if you are not using factory

supplied cabling. See Connector Wiring in the manual for pin

outs.

The Titanium encased sensor has no user serviceable parts. In the

event of a failure, the sensor should be returned to the factory at

the address listed at the end of this manual.

The battery and charging circuit are located inside the electronics

unit and should not need servicing for quite some time. In the

event that the battery weakens or fails, return the unit to the fac-

tory for replacement.

Battery Charging:

Connect the AC Power cord to the CHARGE connector located

on the lower right of the electronics panel. The Red LED will illu-

minate during charging and will extinguish when the battery is

fully charged. While plugged in it will provide a trickle charge

but the LED will be off.

Repair Service:

Should you need to return the system to the factory for service,

send it to the address listed on the last page of this manual. Pack

the unit properly to protect it during shipping. No authorization is

necessary. Please include all your company information for re-

turning the unit.