Product Manual

10
Maintenance
Keep the unit as clean as possible, especially the Electronics key-
pad panel. Do not use an abrasive cleaner on the keypad overlay
or the LCD lens.
The Titanium encased sensor has no user serviceable parts. In the
event of a failure, the sensor should be returned to the factory at
the address listed at the end of this manual.
The battery and charging circuit are located inside the electronics
unit and should not need servicing for quite some time. In the
event that the battery weakens or fails, return the unit to the fac-
tory for replacement.
Battery Charging:
Connect the wall transformer to the CHARGE connector located
on the right side of the case. The Red LED will illuminate during
charging and will extinguish when the battery is fully charged.
While plugged in it will provide a trickle charge but the LED will
be off.
Repair Service:
Should you need to return the system to the factory for service,
send it to the address listed on the last page of this manual. Pack
the unit properly to protect it during shipping. No authorization is
necessary. Please include all your company information for re-
turning the unit.