Manual

Instruction
Manual
SubSurface Instruments Inc.
GAIN
SSI
BATT
Signal Strength and Polarity (-) or (+) are indicated by the
two opposite-facing bar graphs. The signal indications
start in the center-most short bars and fill outwardly in
increasingly larger bars as the signal increases, until
maximum strength is reached.
Polarity is indicated by which set of bars are being filled: (-)
Negative or (+) Positive Side
The Gain Setting in the lower left hand corner is the “GAIN”
bar graph, indicating from left (low) to right (high). By
raising the gain, the locator will become more sensitive to
a weaker target.
The Battery Icon in the lower right corner only appears
when the batteries are getting low. The shape of a battery
appears when the batteries are very close to needing
replacement. Once this starts flashing, only about 5% of
the battery life remains. Always carry spare batteries in the
carrying case and be prepared to replace batteries when
the battery symbol appears. Extensive use of high volume
settings will reduce battery life.
Magnetic Locator
ML-1
ML-1M
Instruction
SubSurface Instruments Inc.
Magnetic Locator
Magnetic Locator
ML-1M
ML-1M
GAIN
ON
OFF
VOL
GAIN
ML-1 KEYPAD
Power On/Off: Press this button to turn the unit ON or OFF
Speaker Volume: is controlled by pressing and holding down
the ON/OFF button. It will cycle from “Low” through “High.”
Repeat the cycle until the button is released. Release the
button at the desired volume.
Gain (Sensitivity) Control Down and Up:
Depress the button with the “DOWN ARROW” to decrease the
sensitivity and depress the “UP ARROW” button to increase
the sensitivity. One click at a time.
Microprocessor Controlled: The Volume and Gain setting
are set in processor memory. When the unity is turned off, it
remembers the last settings, so that when you turn on the unit
again, it will already be adjusted to your previous settings.
Battery Compartment
Loosen the Captive Screw located on the bottom of the
electronics box and remove the cover. Two 9-volt battery slots
are provided. Since there are no “snap” connections to make,
be sure the batteries are placed in the correct “polarity”.
SubSurface Instruments Inc.
1841-C Plane Park Drive
DePere, WI 54115
Phone: 1-877-I CAN FIND IT • Fax: [phone]
www.SSILocators.com • [e-mail]
(1-877-422-6346)