Owners Manual

8 | Sub-Zero Customer Care 800.222.7820

CARE RECOMMENDATIONS

Cleaning

INTERIOR CLEANING

To clean interior surfaces and all removable parts, wash with

a mild solution of soap, water, and baking soda. Rinse and

dry thoroughly. Avoid getting water on the lights, control

panel, and cherrywood facing on wine racks.

Use a standard glass cleaner to clean the UV-resistant glass

door.

CAUTION

Do not use vinegar, rubbing alcohol, or other alcohol-

based cleaners on any interior surface.

STAINLESS STEEL EXTERIOR

Use a nonabrasive stainless steel cleaner and apply with

a soft lint-free cloth. To bring out the natural luster, lightly

wipe the surface with a water-dampened microber cloth

followed by a dry polishing chamois. Always follow the grain

of stainless steel.

CONDENSER CLEANING

CAUTION

Before cleaning the condenser, turn power off at the

control panel. Wear gloves to avoid injury from sharp

condenser ns.

Models UW-24 and UW-24FS: The condenser is located

at the bottom of the unit, behind the kickplate. To access,

remove the kickplate. Refer to the illustration below.

Model BW-30: The condenser is located behind the ip-up

grille. To access, pull out on the bottom edge of the grille

and rotate upward. Refer to the illustration below.

Use a soft bristle brush and vacuum to remove dust and

lint from the condenser. Clean the condenser every 6–12

months.

IMPORTANT NOTE: To avoid damaging the condenser,

vacuum in the direction of the ns.

CAUTION

Failure to clean the condenser could result in tempera-

ture loss, mechanical failure or damage.

CONDENSER

Models UW-24 and UW-24FS

Model BW-30