Installation Guide

IMPORTANT NOTE: For Model UC-24B, install
screws in all the mounting holes in the door
frame. The nature of the door panel with a
narrow outer rim and no connecting center
member requires the support provided by the
glass door.
After the door panel installation is complete,
apply the cover patches or plugs provided over
the holes on the inside surface of the door.
The cover patches or plugs are part of the
insulation system on the door of the
Under
counter unit. Be sur
e to cover all
the holes in the door that were used.
9
Dimensions in parentheses are in
millimeters unless otherwise specified.
UNDERCOUNTER INSTALLATION INSTRUCTIONS
The Model UC-24B glass door is made
with a sealed double-wall tempered glass
core. The drill must not contact this core
when drilling. Be sure the hole is centered
on the small groove in the front of the
door frame and the drill passes squarely
through the frame. If you are inexperi-
enced with drilling, fasten the handle from
t
he rear of the door panel only.
OVERLAY PANEL INSTALLATION
MODELS UC-24R AND UC-24C
R
emove the two panel mounting brackets
attached to the front of the door and set aside.
Place the overlay door panel lying face down
on a protected surface to ensure that the front
is not scratched or damaged.
Position the plastic template (provided) flush
with the lower edge of the door panel. Be sure
you are following the exact location for the
right-hand (RH) or left-hand (LH) door swing.
Refer to the illustrations below for placement
of the mounting brackets.
Once you have located the proper placement
for the brackets, mark the pilot holes, remove
the template and drill pilot holes for mounting
the brackets. It is best to start with a few holes,
position the bracket, drill the remaining pilot
holes and then secure the mounting bracket
with the #8 x
1
/2" screws provided.
23
3
/4" (603)
15
1
/16"
(382)
3
1
/2"
(89)
3
5
/8"
(92)
30
1
/16"
(764)
21
5
/8" (549)
LH DOOR SWING
7
/8"
(22)
23
3
/4" (603)
15
1
/16"
(382)
3
1
/2"
(89)
3
5
/8"
(92)
21
5
/8" (549)
RH DOOR SWING
7
/8"
(22)
Exercise caution when drilling holes for
mounting hardware. This is especially
critical with inset panels.
Overlay Panel Bracket Placement