Installation Guide

INSTALLATION RECOMMENDATIONS
SITE PREPARATION
M
ake sure that the finished rough opening
where the Undercounter unit is to be installed
is properly prepared. Refer to the Installation
S
pecifications illustration for rough opening
dimensions, door swing clearance and location
of electrical and plumbing (Model UC-24C).
IMPORTANT NOTE: To operate properly, the
door must open a minimum of 90˚. Use a
minimum 2" (51) filler in corner installations to
assure a 90˚ door opening. Allow enough clear-
ance in front of the unit for full door swing.
IMPORTANT NOTE: Make sure the floor under
the unit is level with the surrounding finished
floor.
TOOLS AND MATERIALS REQUIRED
The following is a list of tools and materials
that should be available for proper installation.
Appliance dolly able to support 130 lbs
(59 kg)
Level—2' (.6 m) and 4' (1.2 m)
recommended
Phillips and slotted screwdriver sets
Wrench set and allen wrench set
Crescent wrenches
V
arious sized pliers
5
/16" hex bolt nut driver
Drill and assorted drill bits
4' (1.2 m) of
1
/4" copper tubing and saddle
valve for the water line—part #4200880
(Model UC-24C)
Copper tubing cutter (Model UC-24C)
Masonite, plywood,
1
/8" pressed fiberboard,
cardboard or other suitable material to
protect finished flooring
3
Dimensions in parentheses are in
millimeters unless otherwise specified.
UNDERCOUNTER INSTALLATION INSTRUCTIONS
23
7
/8"
(606)
90˚
145˚
MAXIMUM
DOOR SWING
44" (1118)
DOOR CLEARANCE
26" (660)
DOOR CLEARANCE
25
3
/8"
(644)
25
3
/8"
(645)
INSTALLATION SPECIFICATIONS
NOTE: Door swing clearances are based on stainless
steel door and handle dimensions.
34
1
/2"
(876)
R
OUGH
OPENING
H
EIGHT
34
1
/4"
(
870)
M
INIMUM
HEIGHT
REQUIRED
24" (610)
R
OUGH OPENING
WIDTH
15
1
/2"
(394)
2
L
OCATE ELECTRICAL
AND WATER LINE
(MODEL UC24C ONLY)
W
ITHIN SHADED AREA
L
3"
(
76
)
2" (
51)
FRONT VIEW
ANTI-TIP BRACKET
24"
(
610)
ROUGH
O
PENING
D
EPTH
L
OCATE WATER LINE
(
MODEL UC24C ONLY)
WITHIN SHADED AREA
3
15
1
/2"
(394)
1
/2"
(
1
3
)
2" (51)
TOP VIEW
F
NOTE: Water line is required for Model UC-24C only.