User Guide

9
Dimensions in parentheses are in
millimeters unless otherwise specified.
INSTALLATION INSTRUCTIONS
Attach the transition to existing ductwork
with sheet metal screws and duct sealing
tape.
If you are installing an in-line or remote
blower, drill a
7
/8" (22) hole through the
wood framing for the conduit. Refer to the
in-line and remote blower information on
pages 12–13 and follow installation instruc-
tions provided with the blower.
IMPORTANT NOTE: Do not run wiring for the
remote blower through the ductwork.
INSTALL ROUGH-IN PLATE
Use the rough-in plate assembly to deter-
mine the location of wall studs. Position the
rough-in plate in the desired location and
mark the predrilled mounting holes on the
wall.
Install the #10 x 2" (59) screws (included
with the hood liner) through the mounting
holes on the rough-in plate. Verify that the
screws engage the wall studs or framing.
If not, wall anchors must be used.
IMPORTANT NOTE: If additional support is
required for the hood liner, drill supplementary
mounting holes in the rough-in plate and use
these holes to attach the hood liner assembly
to the wall framing.
Rough-In
Plate
Shipping
Screws
Transition
Rough-In
Plate
Soffit
Mounting
Holes
Rough-in plate assembly Hood liner installation
INSTALL THE HOOD LINER
IMPORTANT NOTE: If a backsplash is to be
used, it should be installed before the hood
liner is mounted.
Align both ends of the hood liner assembly
with the ends of the rough-in plate. Refer to
the illustration on the following page.
Insert the back ends of the hood liner
assembly into the rough-in plate and push
the liner assembly toward the wall.
Place the studs on the rough-in plate into
the slots on the hood liner. Use the hex
head nuts (included with the hood liner) to
secure the liner assembly to the rough-in
plate.
Install the remaining #10 x 2" (59) screws
(included with the hood liner) in the lower
section of the liner. Verify that the screws
engage the wall studs or framing. If not,
wall anchors must be used.
Due to the weight of the hood liner, be
sure to have adequate manpower for
installation.