Use and Care Guide

subzero.com | 9
WATER FILTER REPLACEMENT
1 To access the water lter, rotate the bottom of the grille
upward.
2 To remove the old lter, rotate counterclockwise one-
quarter turn, then pull out. Refer to the illustration below.
It is normal for a small amount of water to drip when
the lter is removed. It should be wiped up with a paper
towel or cloth.
3 Remove the new lter from packaging and remove the
plastic cap.
4 Insert the new lter into the manifold, and turn it
clockwise.
5 Once the new lter has been installed, the water lter life
monitor will automatically reset.
Water Filtration System
The water ltration system supplies ltered water to the ice
maker.
IMPORTANT NOTE: Discard the rst two full containers of ice
after each lter replacement.
If the water ltration system will not be used, it can be
bypassed by removing the water lter.
The lter is rated for 750 gallons
(2839 L) or one year, which-
ever comes rst. “Change Water Filter” will appear on the
display when the cartridge needs to be replaced. Touch
“Snooze” to delay the reminder for 24 hours or until the
cartridge can be replaced. Touch “Refresh” to reset the life
indicator to 100% once the lter is replaced.
Replacement Sub-Zero water lters can be ordered online
at subzero.com/store. For questions, contact Sub-Zero
Customer Care at 800-222-7820.
OPERATION
Water lter removal
WATER FILTER