Use and Care Guide
subzero.com | 11
Cleaning
INTERIOR CLEANING
To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water, and baking soda. Rinse and
dry thoroughly. Avoid getting water on the lights.
CAUTION
Do not use vinegar, rubbing alcohol, or other alcohol-
based cleaners on any interior surface.
STAINLESS STEEL EXTERIOR
Use a nonabrasive stainless steel cleaner and apply with
a soft lint-free cloth. To bring out the natural luster, lightly
wipe the surface with a water-dampened microber cloth
followed by a dry polishing chamois. Always follow the grain
of stainless steel.
CONDENSER CLEANING
CAUTION
Before cleaning the condenser, turn power off to the unit.
Wear gloves to avoid injury from sharp condenser ns.
The condenser is located behind the grille. To access, rotate
the bottom of the grille upward. Use a soft bristle brush and
vacuum to remove dust and lint from the condenser. Clean
the condenser every 6–12 months. Refer to the illustration
below.
IMPORTANT NOTE: To avoid damaging the condenser ns,
vacuum in the direction of the ns.
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure, or damage.
VACATIONS
For extended vacations, turn the unit off. Empty the unit and
block doors open to let fresh air in and keep the interior dry.
The water lter should be replaced before start up.
Condenser location
CONDENSER
CARE RECOMMENDATIONS