Installation Guide

12 | Sub-Zero Customer Care 800.222.7820

INSTALLATION

Side-to-Side Adjustment:

1 Loosen the two mounting screws on the upper and/or

lower cabinet hinge. Refer to the illustration below.

2 Use the Allen wrench provided to rotate the adjustment

screw.

3 Verify the hinge is parallel to the side of the unit, then

tighten the mounting screws.

4 Install the hinge pins and door, then verify the door

alignment.

Alignment

DOOR ADJUSTMENT

The doors are adjustable in and out, up and down, and side

to side. In-and-out and up-and-down adjustments are made

on the door. Side-to-side adjustments are made on the

cabinet hinges. To make any adjustments, remove the door

and hinge pins. Refer to the illustration below.

In-and-Out and Up-and-Down Adjustment:

1 Place the door on a protected work surface, then loosen

the two upper hinge mounting screws.

2 Remove the two lower hinge mounting screws, then

remove the lower hinge.

3 Remove the positioning screw from the bottom of the

door, then use the adjustment pin to make up-and-down

and in-and-out adjustments. Refer to the illustration

below. Each vertical hole location adjusts the door

/32"

(1)

. The slotted holes allow for in-and-out adjustment.

4 Once the adjustments are made, install and tighten the

positioning screw.

HINGE

ADJUSTMENT

DOOR HINGE

POSITIONING

SCREW

Door removal

Door adjustment

HINGE

SCREW

ADJUSTMENT

SCREW

Cabinet hinge adjustment