Design Guide

70 | Sub-Zero Customer Care 800.222.7820
WINE STORAGE
Custom Panel—Integrated
For integrated (IW) models, a custom door panel and handle
hardware must be provided. Refer to the panel requirements
chart and typical panel dimensions.
Do not install a solid panel on the glass door unit. A solid
door is available as a sales accessory through an authorized
Sub-Zero dealer.
The thickness of the custom panel can vary. A minimum
5
/8" (16) thick panel is required, but the thickness can be
increased provided it does not exceed the weight limit. The
depth of each integrated model is 24"
(610). Allow for panel
thickness when planning the nished opening depth. Refer
to the full-scale template on page 55.
Finish all sides of custom panels. They will be visible when
the door/drawer is open.
PANEL REQUIREMENTS
WEIGHT PER PANEL MAX
Door Frame (column) 35 lb (16 kg)
Door Frame (tall) 25 lb (11 kg)
Drawer Panel (tall) 15 lb (7 kg)
PANEL THICKNESS MIN
All Panels
5
/8" (16)
UNDERCOUNTER WINE INTEGRATED PRO 48 BUILT-IN
CAUTION
As reveals between cabinetry and the unit decrease,
severe nger pinching can occur while door is closing.
D-style handles are recommended. Door handles must be
located near the edge of the panel opposite the hinge and
should be centered top to bottom. Drawer handles must
be located near the top edge of each panel. Stainless steel
tubular and pro handles are avail able through an authorized
Sub-Zero dealer. For local dealer information, visit the nd a
showroom section of our website, subzero.com.