Installation Instructions

subzero.com | 11
INSTALLATION
Water Line
Approximately 3' (.9 m) of
1
/4" plastic tubing is connected to
the unit with a preassembled
1
/4" compression connection
under the unit. The water line tting connection kit, provided
with the unit, contains a
1
/4" compression union tting for
connection to the household water line.
Purge the water line prior to nal connection to the unit. This
will remove any debris that may be present in the tubing
from installing the new water line. Connect the plastic tubing
from the unit to the house water supply line with the tting
connection kit provided. Check all water line ttings for
leaks.
Locate the water line in the notch as shown in the illustration
below.
IMPORTANT NOTE: If a reverse osmosis system used, it is
recommended that the water ltration system be bypassed
by removing the lter.
IMPORTANT NOTE: Water lines can not be exposed to
freezing temperatures.
WATER LINE
CONNECTION
NOTCH
Water line.
Alignment
ANCHORING
Adjust the depth of the unit to t ush with surrounding
cabinetry. Once aligned, verify doors and drawers open
properly, then install screws in each side trim.
FRONT OF
UNIT
CABINETRY
FACE
FRAME
PANEL
THICKNESS
SCREW
SIDE TRIM
Anchoring.