User Guide

11
To change individual power level settings
to the same setting,
touch the SELECT touch
p
ad until the “BOTH” indicator light is
illuminated.
Enter any power level setting within five
seconds and both elements will be set to
t
hat power level.
If only one element is energized and no
other setting is entered, both elements will
be set to the power level of that element.
If after five seconds no power level is
entered, both elements will be set to the
lower of the two power level settings.
To turn an element off individually, touch
the
SELECT touch pad to select the element,
then touch
OFF ON within 5 seconds. If the
OFF ON touch pad is touched after 5 seconds,
the entire unit will turn off.
To turn both elements off, touch the SELECT
touch pad until the “BOTH” indicator light is
illuminated, then touch the
OFF ON touch pad
within 5 seconds to turn off both elements.
WOLF GRILL MODULE USE & CARE
TIMER OPERATION
The control panel of the grill module has an
independent 99-minute timer. Refer to the
i
llustrations below. This function can be used
with or without the unit in operation. However,
the grill must not be in
Lock mode .
To start the timer, touch the ”
+ ” or ” – ”
s
ymbol until the correct amount of time is
shown in the timer display. The timer will
begin its countdown after a two-second
delay.
A warning beep will sound when the timer
has one minute left and begins to count-
down in seconds starting at 59.
A signal will beep when time has expired
and will continue to beep every 30 seconds.
Touch
CLEAR to reset the timer.
Dimensions in parentheses are in
millimeters unless other
wise specified.
Timer controls
Timer
display
”+
”
and
”–”
symbols
Clear touch pad
CLEAR
touch pad