User Guide

10
WOLF ELECTRIC COOKTOP USE & CARE
O
O
Illuminated touch control panel Lock mode “key” touch pad
CONTROL OPERATION
The Wolf electric cooktop operates by using
high frequency pulsation, cycling the heating
e
lements between zero power and full power.
As the heat is increased on the control panel,
the element will stay at full power for longer
p
eriods and have shorter periods of zero
power.
When using the dual or triple elements, all
sections of the element will cycle at the same
rate. For safety reasons, the outer elements
cannot be turned on independently from the
center section.
ILLUMINATED CONTROL PANEL
The control panel of your electric cooktop is
illuminated for instant visual indication that
any one or more elements are in use. The
control panel features touch controls with
graduated control lighting. The illustrations
below show the control panel of the 36" (914)
framed electric cooktop.
MODES OF OPERATION
LOCK MODE
I
n
L
ock mode
,
all touch pad operations on
the control panel are disabled and all of the
heating elements are deenergized. A steady
g
lowing light within the “
k
ey
”
symbol
indicates that the unit is locked. Refer to the
illustration below.
To lock the control panel, touch and hold
the “
key ” for 3 seconds. The unit will beep
three times and the light within the “
key ”
symbol will illuminate. The control unit is
now in
Lock mode .
To unlock the control panel, touch and hold
the “
key ” for 3 seconds. The unit will beep
twice and the light within the “
key ” symbol
will go out. The control unit is now in
Idle
mode
.
IMPORTANT NOTE: When the unit is powered
up for the first time or if there has been a
power outage, the cooktop will default to
Lock
mode
.
IDLE MODE
After unlocking the control panel as described
in Lock Mode, the unit enters the
Idle mode of
operation. The only valid touch pad operations
are
OFF ON for each element and the Lock
mode
“ key ”.
Lock “key”
touch pad