Installation Guide

18 | Sub-Zero Customer Care 800.222.7820
WATER FILTER BYPASS
If the water filtration system will not be used, it can be
placed in water filter bypass mode by removing the water
filter. Follow these steps to remove the water filter:
1 Pull out on the bottom edge of the access door and tilt
upward.
2 To remove the filter, rotate counterclockwise one-
quarter turn, then pull out. Refer to the illustration
below.
Completion
90° DOOR STOP
A 105° door stop is built into the hinges of tall and column
models. To limit the door swing to 90°, open the door
slightly less than 90°, then use a standard screwdriver
blade to remove the existing clips from each hinge. Locate
the 90° clips from inside the plastic bag containing the
product literature, then insert the 90° clips onto each
hinge. Refer to the illustration below.
CLIP
90° door stop
Installation
WATER FILTER
ACCESS DOOR
Water filter