Installation Guide

subzero.com | 17
Completion
KICKPLATE INSTALLATION
Position the kickplate and install using the two mounting
screws. Refer to the illustration below. The kickplate must
be removable for service. The floor cannot interfere with
removal.
For indoor models, a maximum 6"
(152) decorative kickplate
can be attached to the factory-installed kickplate. The two
rows of vented louvers can be covered if the door panel
is a minimum 4"
(102) from the finished floor. A decorative
kickplate cannot be attached to the outdoor model.
To install a decorative kickplate, remove the paper backing
from the magnets and attach the decorative kickplate to
the magnets. The magnets allow the decorative kickplate
to be removed if necessary.
Turn power on by touching “power” on the control panel.
SCREWMAGNET
Kickplate installation
Installation