Design Guide

subzero.com | 17
Custom Panels
FLUSH INSET PANELS
The flush inset application is an overlay model with flush
inset panels. It is not a separate model.
The flush inset design allows custom panels to be installed
flush with adjacent cabinets. Similar to overlay, flush inset
panels are typically created by combining a ⁄"
(19) custom
panel, a .10"
(3) spacer panel, and a ⁄" (6) backer panel.
Refer to the illustrations for overlay panels.
For flush inset panels thicker than ⁄"
(19), a 90° door stop
may be required to prevent interference with adjacent
cabinets. Refer to the full-scale templates at the end of this
guide.
When installing two units side by side, refer to page 13 for
dual flush inset installations.
ICE AND WATER DISPENSER
For models BI-42SD and BI-48SD, the refrigerator door
panel must include a cutout to accommodate the external
dispenser. The bezel will accommodate a ⁄"
(6) thick
panel for framed applications and a ⁄"
(19) thick panel for
overlay and flush inset applications. Panels thicker than
⁄"
(19) must be routed to ⁄" (22) in the dispenser area
(1⁄"
(29) including the backer and spacer panels).
6
1
/4" (159)
1
/4"
(6)
12
7
/8"
(327)
Dispenser dimensions
Classic Series Refrigeration