User's Guide

 A user guide with required Regulatory verbiage below (FCC statement and IC notice) for the Federal Communication Commission and
Industry Canada must be made readily available to the end user either in hard-copy or electronic form. The usage of the FCC logo either
on the label (for larger devices) or in the user documentation (in this case and typical of physically small transceivers) is required and
governed by FCC usage guidelines. Usage of the logo constitutes a declaration of conformity (DoC) to the FCC rules and regulations.
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee the interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to consult an authorized dealer or service representative for help. Changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Responsible party:
Sub-Zero Inc.
4717 Hammersley Road
Madison, WI 53711
Phone [phone]