Design Guide

Integrated—Press to Open
OPENING DIMENSIONS
W
OPENING WIDTH
25" (635)
OPENING
DEPTH*
84" (2134)
OPENING
HEIGHT
*Additional depth may be required if the electrical location for the press to open accessor
y
is not located at the top of the opening.
NOTE:
3
1
/2" (89) finished returns will be visible and should be finished to match cabinetry.
SIDE
VIEW
TOP VIEW
FRONT VIEW
3
/4" (19)
TYPICAL
FRAMED
CABINETRY
W
FILLER
3
1
/2" (89)
FINISHED
RETURN
FRAMELESS
CABINETRY
W
3
/4" (19)
TYPICAL
3
1
/2" (89)
FINISHED
RETURN
4
1
/2" (114)
A
1
/4" (6)
4
1
/4" (108)
4
1
/2"
(114)
OPENING DIMENSIONS
W A
18" Column and Wine 18" (457) 6" (152)
24" Column and Wine 24" (610) 9
1
/2" (241)
30" Column and Wine 30" (762) 12
1
/2" (318)
36" Column 36" (914) 15
1
/2" (394)
The depth of each integrated model is 24" (610). Allow for
panel thickness when planning the nished opening depth.
A minimum 3
1
/2" (89) nished return is required on all sides
of the opening. Framed cabinets require additional nished
ller material behind the face frame for a proper installation.
Refer to the illustration.
DUAL INSTALLATION
When installing two units side by side in a dual installa-
tion, the opening width is the width of the two units added
together. A dual installation kit is required for this installa-
tion. If a dual installation kit is not specied, a minimum
2"
(51) ller strip is required between units.
Dual installation kits are available through an authorized
Sub-Zero dealer. For local dealer information, visit the nd
a showroom section of our website, subzero.com. For
questions regarding the installation, call Sub-Zero Customer
Care at 800-222-7820.
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical codes.
The electrical supply must be located within the top shaded
area shown in the illustration unless there is at least 1"
(25)
of additional opening depth to route the electrical supply
to the electrical supply at the bottom of the opening. Two
press to open accessories can be plugged into the same
receptacle for dual installations.
A ground fault circuit interrupter (GFCI) is not recommended
and may cause interruption of operation.
ELECTRICAL REQUIREMENTS
Electrical Supply 115 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type
SPECIFICATIONS
IMPORTANT NOTE:
Dimensions in parentheses are millime-
ters unless otherwise specied.