Instruction Manual
12
Remove the paper backing from the lock pocket, align
it with the square holes and the slot in the lower panel,
then press to secure.
13
Install the lock assembly on the upper panel, then use
the key to verify the cam rotates downward.
14
Partially insert a screw in the center hole on each side
of the top set of holes for each panel.
15
Open the drawers and use the positioning screws to
support and align the panels with the mounting
brackets on each side of the drawer.
16
Install and secure the remaining screws through the
brackets and into the panels.
17
Pull both drawers out slightly, then place the 1/4" shim
between the upper and lower drawer panels.
18
To make panels adjustments, refer to the Integrated
Refrigeration Installation Instructions.
19
Verify the operation of the lock, then discard the shim.
20
Align the trim with the bracket on the side of the drawer
and snap into position.
ID-24RO Stainless Steel Panel Installation
subzero.com 800.222.7820
Page 2 of 2