Installation Instructions

subzero.com/specs
Model BI-36R / BI-36F 5
1
/2"
(13)
REFRIGERATOR PANEL
(FRONT OF PANELS)
GRILLE PANEL
36" (914)
9
1
/4"
(235)
69
3
/4"
(1772)
5
/32"
(4)
3
/32"
(2)
3
/32"
(2)
5
/32"
(4)
1
/8" (3)
1
/8" (3)
OVERLAY PANELS
1
/2"
(13)
REFRIGERATOR PANEL
(FRONT OF PANELS)
GRILLE PANEL
9
1
/4"
(235)
69
3
/4"
(1772)
37" (940)
5
/8" (16)
5
/8" (16)
5
/32"
(4)
3
/32"
(2)
3
/32"
(2)
5
/32"
(4)
FLUSH INSET PANELS
Flush inset panel dimensions and mounting cleat offsets. Overlay panel dimensions and mounting cleat offsets.
Cleat Cut Length
PANEL HORIZONTAL VERTICAL
Grille (83" or 84" nished height) 35" (889) None
Grille
(88" nished height) 35" (889) 8" (203)
Door 35"
(889) 65" (1651)*
*No cut required.
Model BI-36R / BI-36F
SINGLE INSTALLATION
Mounting kit is not intended for use with glass door model.
The illustrations below provide panel dimensions and
mounting cleat offsets for overlay and ush inset panels.
Check dimensions of actual panels against the illustration
for your panel application.
IMPORTANT NOTE: Panels are viewed from the front to
show nished elevation. Cleats will be attached to the
back of the panels.
Grille panel dimensions shown are for standard 84"
(2134)
nominal nished height of unit. Grille panel will be 1"
(25)
shorter for 83" (2108) nished height and 4" (102) taller for
88"
(2235) nished height.
Cut mounting cleats to length according to the chart. Cut
lengths will be the same for overlay and ush inset panels.
Horizontal cleats for panel bottoms should be cut to include
as many holes as possible. Refer to page 4 for mounting
instructions.
Mounting cleat offset detail.
OFFSET GAGE
CLEAT
PANEL
OFFSET
(OFFSET PROVIDED IN
PANEL ILLUSTRATION)