Installation Instructions

Wood Side Panel Kit
subzero.com 800.222.7820
Page 3 of 4
HANG THE SIDE PANEL
1 With the side panel held at an angle to the side of the
unit, engage the front brackets behind the main frame.
2
Rotate the back of the panel toward the unit so the
front brackets hook in behind the main frame.
3
Align the rear bracket mounting holes with the pre-
punched locator holes at the back of the unit.
4
Insert the #10 ×
3
/
4
drill PH hex washer screws through
the bracket mounting holes (two for each bracket), then
use a power driver with a Phillips or
5
/
16
” hex bit to
drive the screws into the pre-punched locator holes.
Note: It is not necessary to drill holes into the back of
the unit in order to mount the brackets. It should be
possible to push the screw tips through the unit shell
while spinning the screws clockwise with a power
driver. If a drill bit is used, verify it is a
1
/
8
” (3 mm) drill
bit, but DO NOT penetrate deeper than
3
/
4
” (19 mm).
Main Frame
Main Frame
Side Panel
Side Panel
Note: Side panels must be installed before the unit is
placed in its final position.