Installation Instructions

CONTENTS
6 Screw, #10 ×
3
/
4
" drill PH hex wash
24 Screw, #8-18 ×
1
/
2
" PH truss Hd
3 Bracket, side panel front
2 Bracket, side panel rear
1 Instruction sheet
Note: Side panels must be a minimum of
1
/
2
” (13
mm) thick.
into the side of the panel that will face the unit, 1” (25
mm) from the front edge. This is to accommodate the
main frame and to allow the side panel to fit flush
against the unit side.
2 If the panel is to be mounted on the hinge side of an
over/under model, route a
3
/
16
” (5 mm) deep pocket
into the side of the panel that will face the unit. This is
to accommodate the lower refrigerator hinge plate.
3 After the side panel is cut to size and the appropriate
groove and pocket are routed, use the #8-18 ×
1
/
2
Phillips truss head screws to attach the three front
brackets and two rear brackets.
Wood Side Panel Kit
subzero.com 800.222.7820
7004563 REV. D 05/2018
Page 1 of 4
*7004563$REV.$D*
Side Panel
Main
Frame
Unit
1
7
/
8
” (48)
1
/
8
” (3)
1” (25)
WOOD SIDE PANEL PREPARATION
1 Route
a 1-
7
/
8
” (48 mm) wide,
1
/
8
” (3 mm) deep groove