User Guide

19
Dimensions in parentheses are in
millimeters unless otherwise specified.
KICKPLATE/GRILLE INSTALLATION
Once the unit is leveled and wiring connec-
t
ions made, the kickplate/grille can be
installed.
I
MPORTANT NOTE:
T
he kickplate/grille must
be removed for servicing. The floor cannot
interfere with removal. The louvered section of
t
he kickplate/grille must not be covered so as
to prevent air circulation.
For Models 427 and 427R, there is some
adjustment to the mounting assembly so that
the kickplate/grille can fit flush with the
surrounding area. Refer to illustration 9 below.
IMPORTANT NOTE: The unit must be allowed
to have ventilation through the fins of the kick-
plate/grille. You may cover the solid area, but
do not block the fins. For Model 427R, the
lower drawer panel may hang in front of the
fins, but your baseboard molding must not
cover them.
Turn power back on to the electrical outlet.
DOOR PANELS
Models 427 and 427R are available as a glass
door (G) or solid door (S) model. Each of these
W
ine Storage units are set up at the job site as
either the stainless steel or integrated design.
Stainless steel panels—available as sales
accessories—may be configured several ways
a
nd are shipped separately. Stainless steel
panels are shipped with handles in place.
The integrated design uses custom wood or
other decorative panels and handles provided
by the customer.
Model 427R requires solid panels on the
drawers that may match the door panel, or be
complementary. The Model 427R stainless steel
drawer panel set and stainless steel door panel
are ordered and shipped as two items.
The solid door model—with no glass window
—requires a different door panel than the glass
door design.
Before beginning installation, check for the
correct components for the fit and finish
desired. The door and drawers (Model 427R)
require a decorative panel that is a minimum
5
/8" (16) thick.
IMPORTANT NOTE: For installations at or
above 5,000' (1524 m) in altitude, a special high
altitude glass door unit (HA) must be ordered.
If you have questions, contact your Sub-Zero
dealer or cabinet supplier. Additional panel
information can be found in the Sub-Zero
Design Guide.
MODELS 427 AND 427R INSTALLATION
Illus. 9
PANEL
DESIGN
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.
MODELS
427 | 427R