INSTALLATION GUIDE Model 315W Wine Storage
Contents Important Note Model 315W Wine Storage . . . . . . . . . . . . . . . . . . . . . 3 To ensure the safe and efficient installation of Sub-Zero equipment, please take note of the following types of highlighted information throughout this guide: Model 315W Specifications . . . . . . . . . . . . . . . . . . . . . 4 Model 315W Installation . . . . . . . . . . . . . . . . . . . . . . . 6 Installation Checklist . . . . . . . . . . . . . . . . . . . . . . . . . 10 Service Information . . . . . . . . . .
Sub-Zero Model 315W Wine Storage 3 subzero.com/specs Model 315W Wine Storage IMPORTANT NOTE: The importance of the installation of the undercounter wine storage unit cannot be overemphasized. Installation must be completed by a qualified installer. RATING PLATE Read this entire installation guide prior to installation. There are key details that you should observe during the installation to make the process easier, problem-free and, most importantly, safe.
Model 315W Specifications 4 Model 315W Specifications OVERALL DIMENSIONS 15 1/8" (384) INSTALLATION 24" (610) TOP VIEW 24" (610) OPENING DEPTH 341/16" (865) 4" (102) 24" (610) OPENING DEPTH 341/2" (876) 151/4" OPENING HEIGHT (387) OPENING WIDTH 16 5/8" (422) SIDE VIEW FRONT VIEW 1 3/4" (44) Overall dimensions are based on stainless steel panels and handles. NOTE: Door swing is not reversible.
Model 315W Specifications 5 subzero.com/specs Area Requirements Electrical Requirements Before moving the unit into place, make sure the opening dimensions, door clearance and electrical service are correct. Refer to the illustrations on the previous page. Model 315W must be installed with adequate clearance for electrical connection at the rear of the unit. The electrical supply requires installation of a grounded receptacle on a separate circuit, servicing only this appliance.
Model 315W Installation Unpack the Unit Before moving the wine storage unit into position, make sure the opening dimensions and electrical requirements are complete and accurate. IMPORTANT NOTE: The floor under the wine storage unit must be at the same level as the surrounding finished floor to allow for removal of the unit for servicing. Use an appliance dolly to move the wine storage unit near the installation opening. Position the dolly at the side of the unit to prevent damage to finished surfaces.
Model 315W Installation 7 subzero.com/specs Installation IMPORTANT NOTE: If the wine storage unit has been laid on its back or side, you must allow the unit to stand upright for a minimum of 24 hours before connecting power. To determine the horizontal or vertical level point, place a 2' (.6 m) level along the top of the unit or on either exterior side of the unit. In order to access these leveling positions, the unit will have to be slightly out of the opening.
Model 315W Installation 8 Kickplate Panel Specifications INSTALL KICKPLATE Model 315W is offered in two design applications; stainless steel (/S) and overlay (/O). Each of these designs have a full-view glass door. Once the wine storage unit is in position, install the kickplate using the screws provided. Refer to the illustration. There is some adjustment to the mounting assembly so that the kickplate will fit flush with the surrounding area. The kickplate must be removed for servicing.
Model 315W Installation 9 subzero.com/specs Overlay Panel Installation Inspect the overlay door panel for minimum thickness, weight limit and finished inside edges. Decide if the handle will be attached through the glass door frame or just through the decorative door panel. If it is just through the door panel, the handle must be attached first. 5/8" The overlay panel is attached using #8 x square drive screws passing through the door frame from the rear, behind the gasket into the panel.
Model 315W Installation Overlay Panel Installation The model 315W glass door is made with a sealed, double-wall tempered glass core. The drill must not contact this core when drilling. Be sure the hole is centered on the small groove in the front of the door frame and the drill passes squarely through the frame. If you are inexperienced with drilling, fasten the handle from the rear of the door panel only.
Service Information 11 subzero.com/specs Service Information If service is necessary, maintain the quality built into your wine storage unit by calling Sub-Zero factory certified service. For the name and number of Sub-Zero factory certified service nearest you, check the contact & support section of our website, subzero.com or call Sub-Zero customer care at 800-222-7820. If you are storing or disposing of your old refrigerator or freezer, please do it safely.
SUB-ZERO, INC. P. O. BOX 44848 MADISON, WI 53744 7012206 REV-A 9/2011 SUBZERO.COM 800.222.
