INSTALLATION GUIDE Steamer Module
Contents Important Note Wolf Steamer Module . . . . . . . . . . . . . . . . . . . . . . . . . . 3 To ensure the safe and efficient use of Wolf equipment, please take note of the following types of highlighted information throughout this guide: Steamer Module Specifications . . . . . . . . . . . . . . . . . . 4 Steamer Module Installation . . . . . . . . . . . . . . . . . . . . . 8 Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . .
Wolf Steamer Module 3 wolfappliance.com/specs Steamer Module Installation IMPORTANT NOTE: Installation of the Wolf electric steamer module must be completed by a qualified installer. Read this entire installation guide prior to installation and save for the local inspector’s reference. The homeowner should keep this installation guide for future reference. This appliance must be installed in accordance with National Electrical Codes, as well as all state, municipal and local codes.
Steamer Module Specifications Overall Dimensions 4 Installation Specifications STEAMER MODULE Failure to locate the steamer module without the proper clearances will result in a fire hazard. 21" (533) IMPORTANT NOTE: Installation of the Wolf electric steamer module must meet minimum clearance requirements shown in the installation illustration on page 6. 15" (381) 7 1/2" (191) 6" (152) DRAIN OUTLET 1/2" (13) SIDES 1" (25) FRONT / BACK The Wolf steamer module is intended for indoor use.
Steamer Module Specifications 5 wolfappliance.com/specs Electrical Requirements Verify that power is disconnected from the electrical box before proceeding. The Wolf electric steamer module requires a separate, grounded 3-wire electrical supply with its own circuit breaker. Locate the electrical supply within the shaded area shown in the installation illustration on the following page. MODEL IS15/S • Power supply: 240/208 V AC, 60 Hz, 15 amp service. • Max connected load: 2.6 kW at 240 V, 1.
Steamer Module Specifications 6 Installation Specifications STEAMER MODULE SIDE CABINET 30" (762) min COUNTERTOP TO COMBUSTIBLE MATERIALS 13" (330) max 7" (178) TO COMBUSTIBLE* SEE COUNTERTOP CUT-OUT BELOW 7" (178) TO COMBUSTIBLE* 12 3/8" 12 3/8" (314) (314) DRAIN OUTLET 7 5/8" (194) 36" (914) 18" (457) min 13 1/2" (343) 6" DRAIN OUTLET (152) FLOOR TO COUNTERTOP E 15" (381) 15" (381) SIDE VIEW FRONT VIEW *Minimum clearance from cooktop cut-out to combustible materials up to 18" (4
Steamer Module Specifications 7 wolfappliance.com/specs Installation Specifications MULTIPLE COOKTOP INSTALLATION If the steamer module is to be used in combination with additional cooktops or modules with a filler strip, refer to the chart below for the countertop cut-out width. The dimensions are derived by adding an additional 11/4" (32) for each additional unit, to give you the total countertop cut-out width. Dimensions include the filler strip.
Steamer Module Installation 8 Install the Module Remove the steamer module from its shipping carton and discard packing materials. Lower the steamer module into the countertop cut-out opening. Center the module in the opening and check that the front edge of unit is parallel to the front edge of the countertop. Check that all minimum clearances are met. Using a pencil, outline the rear edge of the module frame on the countertop. Remove the module from the opening.
Steamer Module Installation 9 wolfappliance.com/specs Before Operating Read the entire Wolf steamer module use & care guide included with the unit. It contains important safety, operation, service and warranty information. Before operating, clean the steamer module thoroughly with hot water and a mild detergent. Rinse and dry with a soft cloth. This removes any residual oil and grease left on the surface from the manufacturing process. Refer to care recommendations in the use & care guide.
Service Information 10 Troubleshooting Service Information IMPORTANT NOTE: If the steamer module does not operate properly, follow these troubleshooting steps: If service is necessary, maintain the quality built into your steamer module by contacting Wolf factory certified service. • Verify that electrical power is being supplied to the module. • Check the electrical connections to ensure that the installation has been completed correctly.
The information and images in this guide are the copyright property of Wolf Appliance, Inc. Neither this guide nor any information or images contained herein may be copied or used in whole or in part without the express written permission of Wolf Appliance, Inc. ©Wolf Appliance, Inc. all rights reserved. Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc.
WOLF APPLIANCE, INC. P. O. BOX 44848 MADISON, WI 53744 819442 REV-A 5/ 2011 WOLFAPPLIANCE.COM 800.222.
