Tus neeg siv phau ntawv

8
[e-mail]
Wiring: RetroSound Radio® | Direct Connection
Connect the Quadraphonic amplifier directly to your RetroSound® radio by
connecting the power connector (black) and speaker connector (brown) from
the amplifier to the Main Harness. Next, connect the black GROUND lead to
a suitable grounding point and the yellow CONSTANT lead to the vehicle’s
battery (see page 6). Connect the front & rear speakers to the output side
of the amplifier using the Speaker Harness supplied with your RetroSound
Radio. Refer to the Installation and Assembly Manual for instructions on
how to connect the Power Harness. This amplifier is NOT bridgeable.
REMOTE/AMP TURN-ON (Blue/White)
POWER
QUAD4
Input Side (from radio)
Output Side (to speakers)
MAX
HPF FULL
GAIN
MINMAXMIN
GAIN
HPF FULL
X-OVER
FRONT REAR
Connect ground to chassis or
frame close to the amp.
to speakers and power connections
from radio
15 amp
fuse
Leave RCA
connection
capped when
not in use.
POWER ANTENNA (Blue)
GROUND (Black)
Left Rear Speaker
Green (+)
Green/Black (-)
Left Front
Speaker
White (+)
White/Black (-)
Right Front
Speaker
Gray (+)
Gray/Black (-)
Right Rear Speaker
Purple (+)
Purple/Black (-)
IGNITION/ACC (Red)
Connect yellow lead to battery.
Connect black lead to ground.
GROUND (Black)
CONSTANT +12 Volt (Yellow)
CONSTANT +12 Volt (Yellow)
Power Harness
Included with RetroSound Radio
Speaker Harness
Included with RetroSound Radio
Main Harness
Included with RetroSound Radio
Power Connector
Speaker Connector