MSDS

MATERIAL SAFETY DATA SHEET

U.S. Department of Labor

Occupational Safety and Health Administration

SECTION 1

IDENTIFIERS

COMPANY: Styro Industries

ADDRESS: 390 Viking Circle, Rio, WI 53960

EMERGENCY PHONE NUMBER: 888-702-9915 (888-702-9916 fax)

PRODUCT IDENTIFIER: Tuff II

PRODUCT USE: Water based sanded acrylic coating

EFFECTIVE DATE: 09/2011 - Prepared by Robert Krehl

(888-702-9915)

SECTION 2

COMPOSITION

Chemical Name

CAS No. %B.W. TLV

Acrylic resin emulsions proprietary 20-30 not established

quartz silica 14808-60-7 45-55 0.1 mg/M

hydrated aluminum silicates 1332-58-7 4-6 5 mg/M

water 7732-18-5 8-12 not hazardous

surfactant 9016-45-9 1-3 0.5 ppm PEL

titanium dioxide 13463-67-7 8-12 5 mg/M

antifoam 64741-88-4 1-3 5 mg/M

ester alcohol 25265-77-4 2-4 not established

hydroxyethyl cellulose 9004-62-0 1-3 not hazardous

propylene glycol 000057-55-6 2-7 not hazardous

preservatives (DCOIT) 2634-33-5 <1 not established

ammonia 1336-21-6 <1 25 ppm

* Note - as respirable dust (or mist).

Generic Description: A water-based thixotropic mixture containing 100% acrylic resins, extenders, and

modifiers.

SECTION 3

HEALTH HAZARD EFFECTS

Skin Contact: May be a mild skin irritant.

Skin Absorption: No known hazards.

Eyes: Damaging to the eyes.

Inhalation: Prolonged inhalation of vapors may cause irritation to the upper respiratory tract.

Ingestion: Harmful if swallowed.

Styro Industries Tuff II Page 1 of 4

PAGE 1
MATERIAL SAFETY DATA SHEET U.S.
PAGE 2
SECTION 4 FIRST AID INSTRUCTIONS Skin Contact: Wash exposed area with a soap solution or water. Eye Contact: Immediately flush eyes with water for 15 minutes. Immediately contact a physician for additional treatment. Inhalation Exposure: Remove victim from contaminated area to fresh air. Apply appropriate first aid treatment as necessary. Ingestion: Do not feed anything by mouth to an unconscious or convulsive victim. Specific: Do not induce vomiting. Immediately contact a physician.
PAGE 3
SECTION 8 EXPOSURE CONTROL - SPECIAL PROTECTIVE EQUIPMENT Ventilation Protection: Adequate ventilation. Recommended Respiratory Protection: If ventilation is inadequate, use a mask with dust/mist/fume cartridges. Recommended Skin Protection: Rubber gloves. Other Protective Equipment: Full coveralls. Recommended Eye Protection: Splash proof chemical goggles. Personal Hygiene: Wash thoroughly after handling product.
PAGE 4
SECTION 13 DISPOSAL INFORMATION Disposal Instruction General: Dispose in accordance with local, state, and federal regulations. SECTION 14 TRANSPORTATION Not regulated for transportation. DOT - not hazardous. IMO - not hazardous. SECTION 15 REGULATIONS WHMIS CLASSIFICATION: FIFRA (40 CFR): EPA Reg. No. NONE - Not Hazardous under WHMIS NONE USED. OSHA (29CFR Sec. 19l0) - Safety and Health Standards: See Section 2 above.