MSDS

Styro Industries FP Ultra Lite Panels Page 3 of 3
SECTION 8
SPECIAL PROTECTIVE EQUIPMENT
Ventilation Protection: Use adequate ventilation if grinding of the panels takes place.
Recommended Respiratory Protection: If grinding takes place and ventilation is inadequate, use a mask
with dust/mist/fume cartridges.
Recommended Skin Protection: Work gloves.
Other Protective Equipment: Full coveralls.
Recommended Eye Protection: Safety glasses.
Personal Hygiene: Wash thoroughly after handling product.
SECTION 9
STORAGE AND HANDLING PRECAUTIONS
Storage Instructions: Keep away from extreme heat, open flame. Keep the back side of the panels out of
direct sunlight until installed to prevent UV deterioration.
Handling Instructions: Normal building material handling.
SECTION 10
REGULATIONS
FIFRA (40 CFR): EPA Reg. No. NONE USED.
OSHA (29CFR Sec. 19l0) - Safety and Health Standards:
See Section 2 above.
FDA (2lCFR) Ingredients Authorized Under: None
This form is intended for general compliance with New Jersey and Pennsylvania freedom of information
legislation, California proposition 65, and the noted sections of the Code of Federal Regulations.
This form is essentially equal to OSHA 20 Form. While the information and recommendations set forth
herein are believed to be accurate as of the date hereof, Styro Industries makes no warranty with respect
this information. Recipients are advised to confirm, in advance of need, that the information is current,
applicable, and suitable to their circumstances.